Machinery Regulation·Annex XII
Articles / Annexes↓
Chapter I — GENERAL PROVISIONS
- 1Subject matter
- 2Scope
- 3Definitions
- 4Free movement
- 5Protection of persons during installation or use of machinery or related products
- 6Categories of machinery and related products listed in Annex I subject to relevant conformity assessment procedures
- 7Safety components
- 8Essential health and safety requirements for products within the scope of this Regulation
- 9Specific Union harmonisation legislation
Chapter II — OBLIGATIONS OF ECONOMIC OPERATORS
- 10Obligations of manufacturers of machinery and related products
- 11Obligations of manufacturers of partly completed machinery
- 12Authorised representatives
- 13Obligations of importers of machinery and related products
- 14Obligations of importers of partly completed machinery
- 15Obligations of distributors of machinery and related products
- 16Obligations of distributors of partly completed machinery
- 17Cases in which obligations of manufacturers apply to importers and distributors
- 18Other cases in which obligations of manufacturers apply
- 19Identification of economic operators
Chapter III — CONFORMITY OF PRODUCTS WITHIN THE SCOPE OF THIS REGULATION
- 20Presumption of conformity of products within the scope of this Regulation
- 21EU declaration of conformity of machinery and related products
- 22EU declaration of incorporation of partly completed machinery
- 23General principles of the CE marking
- 24Rules for affixing the CE marking to machinery and related products
Chapter IV — CONFORMITY ASSESSMENT
Chapter V — NOTIFICATION OF CONFORMITY ASSESSMENT BODIES
- 26Notification
- 27Notifying authorities
- 28Requirements relating to notifying authorities
- 29Information obligation of notifying authorities
- 30Requirements relating to notified bodies
- 31Presumption of conformity of notified bodies
- 32Use of subcontractors and subsidiaries by notified bodies
- 33Application for notification
- 34Notification procedure
- 35Identification numbers and lists of notified bodies
- 36Changes to notifications
- 37Challenge of the competence of notified bodies
- 38Operational obligations of notified bodies
- 39Appeals against decisions of notified bodies
- 40Information obligation of notified bodies
- 41Exchange of experience
- 42Coordination of notified bodies
Chapter VI — UNION MARKET SURVEILLANCE AND UNION SAFEGUARD PROCEDURES
Chapter VII — DELEGATED POWERS AND COMMITTEE PROCEDURE
Chapter VIII — CONFIDENTIALITY AND PENALTIES
Chapter IX — TRANSITIONAL AND FINAL PROVISIONS
Annexes
- ICATEGORIES OF MACHINERY OR RELATED PRODUCTS TO WHICH ONE OF THE PROCEDURES REFERRED TO IN ARTICLE 25(2) AND (3) SHALL BE APPLIED
- IIINDICATIVE LIST OF SAFETY COMPONENTS
- IIIESSENTIAL HEALTH AND SAFETY REQUIREMENTS RELATING TO THE DESIGN AND CONSTRUCTION OF MACHINERY OR RELATED PRODUCTS
- IVTechnical documentation
- VEU DECLARATION OF CONFORMITY AND EU DECLARATION OF INCORPORATION
- VIINTERNAL PRODUCTION CONTROL — (Module A)
- VIIEU TYPE-EXAMINATION — (Module B)
- VIIICONFORMITY TO TYPE BASED ON INTERNAL PRODUCTION CONTROL — (Module C)
- IXCONFORMITY BASED ON FULL QUALITY ASSURANCE — (Module H)
- XCONFORMITY BASED ON UNIT VERIFICATION — (Module G)
- XIASSEMBLY INSTRUCTIONS FOR PARTLY COMPLETED MACHINERY
- XIICORRELATION TABLE